Nmap scan report for takshak-bambi (192.168.1.91) Nmap scan report for neufbox (192.168.1.1) Use the nmap command in the following way: It is advisable to use root privileges while scanning the network for more accurate information. Step 3: Scan to find devices connected to your network You may also use ip a command to know your IP address in Ubuntu and other Linux distributions.Īt the same time, I’ll recommend you to read about basic Linux networking commands for more information. The important things are highlighted in bold.

TX packets:2013773 errors:0 dropped:0 overruns:0 carrier:0 RX packets:2135051 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Wlan0 Link encap:Ethernet HWaddr 70:f1:a1:c2:f2:e9 Look for wlan0 if you are using wifi or eth0 if you are using Ethernet. Use the ifconfig command to find the IP address in Linux. Now we need to know the IP address range of the network.

It should be in the official software repository. You can easily install it in other Linux distributions as well. Use the following command to install nmap in Ubuntu based Linux distributions: sudo apt-get install nmap Nmap is one of the most popular network scanning tool in Linux. Using Linux command to find devices on the network Step 1: Install nmap If you don’t remember the router password or you don’t want to go that way, here’s what else you could do. Enter the username and password and you can see all the details and devices connected to the router. This is usually the browser interface for your router. Check your gateway ip address and then type it in a browser. The process is very simple and easy to use even for beginners.īefore you see any of that, let me tell you that your router should also be able to show all the connected devices. We will use both, command line and GUI, way for finding out what devices are connected to your local network in Linux.

Osirix md version too many devices